When I open up the throttle when in gear and riding. The engine seems like it going to stall and than excelerates as normal . The same problem occur in also gears shifts. Any suggest for a fix would be appreciated.
Hey folks just thought I’d share an issue I had (hopefully resolved) with my 2023 R3 GT from new out of the showroom. When I was only slightly throttling on, the engine revs would fade slightly, then with a bit more throttle it would accelerate fine; this was particularly rude when throttling up...
Seems nothing with this bike is easy. Has anyone balanced the throttle bodies on this bike yet? I'm looking into the procedure and hitting some roadblocks. The steps are detailed on pages 146 - 148 of the manual.
You have to remove the tank to clear the Plenum to get to the throttle body...
Someone told me that even with a tune the R3 still limits power by pulling timing and partially closing the throttle bodies over ruling the throttle table we have access to per 7k revs
Wondering if the future holds a higher rev limit similar to the previous version.
Hey,
So, I'm not an expert but I do have Tune ECU to check in on stuff. My Rocket Setup is:
Triumph Rocket 3 Roadster 2018
RAM Air Kit
Dave Platt Custom Silencers (Deep Tone System) with Free Cross Over Pipe
Tune Map: Hans0 Tune for 2014+ ROADSTERS, TORS, TRIPLE/RAMAIR FILTERS, ECT.
Hans0...
I just bought a 2015 Touring and she'll be taken on a lot of long rides. My right hand goes numb very quickly if I can't shake it out regularly so a good throttle lock or cruise control is essential.
The bike is in Spokane Washington and I'll fly up and drive her home to Phoenix as our first...
I just bought one, but they only seem to list one at a time in Aussie $ or Euros on different eBays. They have listed, sold and re-listed these before. As one sells like mine he cancels the other currency listing.
Aussies have to pay a flat 10% GST on item and postage. Some listings include in...
Ok all of you talented troubleshooters here's one for you. Friend of mine's R3Roadster would not idle. So not knowing any better, he adjusted the throttle stop screw, located where the cables attach at the throttle body! He got it to idle but is was a bouncing idle, this is after he got a MR12...
My 2011 Roadster is popping back through throttle body and hesitating at 2000 to 3000 rpm. Since replacing MAP sensor and vacuum lines. Symptoms were similar but much worse when the sensor sent a code. I replaced it but it's not back to 100 percent. Any ideas what else.? Coil connections are...
I am sure this has been addressed in this forum before, but...well, I can't seem to find it!
Does anyone have any recommendations for a self installed throttle lock device that actually, safely, gives some degree of holding the throttle in place. I have arthritis in my throttle hand, and...
I have a rocket 3 which has a ramair kit fitted. but I just can't seem to get it to run right. as I first open the throttle I get a small cough or stutter as if the bike is going to cut out.
I have set the TPS, and fitted a new stepper motor. I have tried 2 TPS sensors, using ECU tune I have set...
Due to a few requests on my Youtube channel, coupled with a lack of a sticky/central thread on here, I took an hour on rainy Saturday and made this video showing how to balance or synchronise the throttles on the Rocket III.
Hopefully it will be of some use.
Brahma is not feeling well this morning. Start up was normal. I let him idle while I put his cover away. As I pulled away from the house, I noticed a lot of play in the throttle. Then the throttle hit a new STOP. I can get up to 10mph and no more. The enigine barely revs at all. I rode him back...
So I just got TuneECU working after recieving my Lonetec cable. I just got this bike 2 weeks ago. It has an intermittent high idle issue and some popping on idle as well.
This is what I found upon connecting TuneECU.. Could this be causing my issues:
Check this out. Your throttle might be only opening to 90% or a little better (both my engines' throttles are like this)
Will this, if corrected, free up a little more tq/hp on the dyno?
Discuss!