airbox

Recent contents Top users
  1. sonnie

    Airbox intake sound after starting.

    Has anyone noticed a sound change of the airbox after just a minute or so or idling. ?? Sounds as if there is a baffle opening in the intake.
  2. pica

    Chewed wire prevention airbox

    I invited a friend that lives nearby to ride motorcycles and borrowed him my crf for this ride. In preparation I rode that bike the day before to test everything and found that blinkers, horn, brake light, wasn't working. Later on found thre chewed wire, then the burned fuse , the hole in...
  3. Wdugan9080

    Hi new here 08' R3T with TOR's and airbox K&N

    New to me 3 months ago, Looking for more power got got 20368.hex installed, Seem's rich, just adjusted TPS, and Secondary TPS, and Idle stepper motor, sprayed some cleaners in map sensor, and TB cleaning, and ran fuel injector cleaner thru 18 gal's of gas 1oz/gallon at a time, runs fine, just...
  4. Mittzy

    T1292006 Sensor, Pressure, Airbox - What doe it do?

    I know what this part is - but I dont know how much influence this part has on the tune and the running of the bike. I have 2 roadsters, 1 has 230hp and airbox intact and the above mentioned part still installed but all airbox plumbing removed - Bike runs great. 2nd Roadster is 250Hp with ALL...
  5. bernard

    Airbox removal/ breather access

    I need to put a filter on the crankcase breather, but I can't even get my hands in there. So I'm trying to remove the airbox for access. After unbolting, the manual says to "manoeuvre" the airbox out of the frame. I'm trying to pull it from the right side, but it's very stubborn. Especially...
  6. Bigjaype

    Airbox Temperature

    Hi Guru's...anyone have any idea about how hot the air-box gets? As I have removed all the bits post my Ramair installation and am using it for storage and to house the remote controller unit. Problem is, I have had my second remote control unit fail. The first was admittedly a cheapie off eBay...
  7. Skanska161

    For sale

    Triumph Rocket 3 Stock Air Box | eBay Triumph Rocket 3 Wiring Harness | eBay Triumph Rocket 3 Fuel Rail W/ Injectors | eBay Triumph Rocket 3 Stock Mid Pipe (CAT) | eBay Triumph Rocket 3 Genuine Windscreen | eBay Triumph Rocket 3 Touring Stock Pipes | eBay triumph rocket3...
  8. SMLWNKR

    Airbox Elimination

    Searched hard but could not find this info. I purchased a 2006 R3 Classic and the previous owner had installed the 3 K&N filters and had an unknown tune it. It ran great. The bike then developed a stumbling issue at highway speeds. The dealer could not fix it and requested I go back to stock so...
  9. Pumbaa

    Need more Air

    Firstly my apologies if this has been asked and answered before, I am still trying to find my way around all the posts. I have already had my air box removed and had the 3 K&N filters installed under my Bear Claw, but have recently been thinking about getting rid of the Bear Claw and doing a...
  10. cl2eep

    2016 Roadster, D&D Slip Ons, K&N in the stock airbox

    So I recently got my 2016 Roadster and one of the great things about my dad having a 2005 Classic is that i can raid his cast off box for parts! I picked up a K&N filter for the stock air box and a set of D&D Slip ons he ran before he got his Jardines. The bike sounds WAY better and looks way...
  11. Anomaly

    Airbox removal (not just snorkel/air duct)

    Has anyone removed the airbox/air filter housing? I installed the Ramair filter, yet would like to eliminate the airbox so I can install a second battery in it's place.
  12. flyreels

    Want to Buy Airbox plenum, rubber couplings and clamps

    Wanted all the old pluming, Airbox plenum, rubber couplings and clamps etc as I want to start a new air filter project, so any one that has them laying around and wants to get rid of them at a reasonable price please send me a PM. Cheers Pete
  13. Boudreaux

    Airbox Removal???

    Is this a complicated task? I have Reband Pipes on there way and I wanna go with filters directly to the Throttle Bodies. I did this on my 109 and there were sensors, PCV and temp. Is there anything I need to know ahead of time so I dont run into any surprises? Any help will be greatly...
  14. dbutton12

    airbox....finished product

    It hasn't had an official road test yet, but I have had it running and I'm glad I put the insulation/sound deadener on the airbox. Prior to this, I ran it and you could hear a thrumming sound, which I could change by placing my hand on the back of the airbox (which is the largest flat sheet of...
  15. dbutton12

    Scratch-built airbox

    This project actually began because I wanted to use the stock airbox for my amp. After looking over the filter/airbox possibilities available for the R3T I decided I would have to be creative. I have always preferred a symetrical look, so I started researching velocity stacks.....you know, old...
  16. airbox#2

    airbox#2

    As you can see it is a tight fit. I'm glad I moved them forward since my knee fits just where it should just behind the rear filter. All I have to do yet is insulate the exterior with heat rejecting tape and permanently glue the box to throttle body grommets in place. I like the symmetry of the...
    • dbutton12
    • Media item
    • air filters airbox bearclaw
    • Comments: 0
    • Category: General Album
  17. airbox#2

    airbox#2

    As you can see it is a tight fit. I'm glad I moved them forward since my knee fits just where it should just behind the rear filter. All I have to do yet is insulate the exterior with heat rejecting tape and permanently glue the box to throttle body grommets in place. I like the symmetry of the...
    • dbutton12
    • Media item
    • air filters airbox bearclaw
    • Comments: 0
    • Category: General Album
  18. airbox#2

    airbox#2

    As you can see it is a tight fit. I'm glad I moved them forward since my knee fits just where it should just behind the rear filter. All I have to do yet is insulate the exterior with heat rejecting tape and permanently glue the box to throttle body grommets in place. I like the symmetry of the...
    • dbutton12
    • Media item
    • air filters airbox bearclaw
    • Comments: 0
    • Category: General Album
  19. airbox#2

    airbox#2

    As you can see it is a tight fit. I'm glad I moved them forward since my knee fits just where it should just behind the rear filter. All I have to do yet is insulate the exterior with heat rejecting tape and permanently glue the box to throttle body grommets in place. I like the symmetry of the...
    • dbutton12
    • Media item
    • air filters airbox bearclaw
    • Comments: 0
    • Category: General Album

  20. MGS custom airbox

    The airbox and the Jardines are on the bike. Ya all know how good the Jars are, so I'll skip telling you how much I like them. LoL The airbox and the bearclaw look good. They blend in very well with the bike. The black bearclaw looks so much better than the chrome one. I'll get some...
Back
Top