Clutch Rebuild

I have not posted on this because your doing well and Peter knows just as much if not more !!! I was looking at yoir cam chain guide to see which early version you had. And noticed something I believe I've not seen before so you can look at whether it should be there or not. Well and im not done with my first cup of coffee and I am on the technical library

Anyway highlighted below the hex shapes is what caught my eye.


Or am I not holding my face straight. It sure looks like part of the casting. I will have to look at some of my engine pictures to see if its there.
 
Last edited:

Warp, I'll go and look today and take a better photo I have no idea what that is, hopefully I don't have some sort of "one off".

Had a good look over the cam chain guide and it looks OK, if you don't mind for my reference what is the difference between the versions?
 
Help needed.

Fitted Detent Spring last night and then referred to other images off the forum, is there a right and wrong way round? I fitted the detent spring the same way the old one came off.

Does the spring go over or under the pin it locates on? Mine was under all the images I see are over. Was a right b*std to get it fitted that way.
 
Spring goes over pin. Probably more important is hook goes thru the detent arm from fore to aft. Which if wound right should leave the hook going over the pin. And makes it easier to install. I am curious as to which detent spring you got. The original or the new one that goes with the new smaller diameter detent wheel.
 
You must log in or register to reply here.

Similar threads

Hydraulic clutch woes
Replies
2
Views
651
R-III-R Turbo
Jumping out of 4th gear - Gearbox rebuild
Replies
9
Views
2K
JonesyVRUK
No start... starter? Rebuild it?
Replies
9
Views
3K
Mongler07
Clutch slippage/4th gear issues
2
Replies
15
Views
2K
Journeyman
Clutch Lifter Shaft
Replies
8
Views
2K
Claviger
Menu
Log in
Register