rocket

Hi fellow Rocketeers 🙂 I've been bumbling round on my Rocket for a few years and I'm looking to see if there might be anywhere in the UK (or maybe even Europe) that might sell replacement chrome parts for 2004 Rocket 111s. Long story cut short, the chrome parts have become pitted/rusted and are...

I am looking to find cylinder compression data, as I would to cross check/verify mine against data. if someone has it, please share Either 2.3L or 2.5L , either one works Thanks

I pulled my bike out. Had it running for a minute and warming up getting ready to take a ride and suddenly started Misfiring ignition was changed a year ago. Can’t find any loose wires. Everything seems fine. Was tuned up less than a year ago. Any ideas?

Greetings from NJ 2025 storm gt . Owned it about a year or so. So far so good.

I can probably count on one hand the times I've seen another Rocket in the wild, other than our organized rides. Today, the owner of this immaculate 2013 Touring was also passing through Jonesborough, TN. The owner and his brother stopped by to say hi as I was gearing up to leave and he kept...

Hi i just flashed the bike for the 1st time everything seemed to go ok until i checked the error codes and i managed to clear the cruise control one , but my check engine light is now on with the error crankshaft position not adapted , it says to clear this adapt the crank position and then...

After fitting IXIl exhaust on my 2025 Storm R I noticed a casting mark underneath the paint finish on Swing Arm - Contacted Triumph via my local dealer and was told that this mark is a Casting Mark and not a defect and is normal and present on all Rocket 3 models - it is usually hidden behind...

My 2024 Rocket 3 GT has a problem that I will post in tech. Me....69 years old life long motorcycle nut

So I have been having issues with the clutch on my 2005 rocket 3. I had the clutch lifter piece friction weld to the shaft and shear off. I suspect the clutch wasn't entirely disengaging. I have since replaced the lifter piece, lifter piece bearing, lifter shaft and pressure plate to upgrade...

I sent them email asking about price and when it will be ready for sale and now it is, I have to change my rotor because oem rotor has excessive play in it because of steel quality issues and its clunks when I move bike back and forth and use rear brake, even clunks when I move rotor by hand...

Hello Everyone, Just purchased a set of Motea Crashbars for 2014 Rocket. They don't come with mounting instructions. Does anyone know where I might find some installations instruction for the bars?

Hi I recently purchased a used 2005 rocket 3 and right away it needed tires. I removed the front wheel and noticed there was only 1 front wheel spacer but the tire looked center and also the brakes. After doing some research everything Ive read says there should be 2 spacers. Has anyone else ran...

I have been a Rocket III owner for 19 years. Puchased my new 2006 in August of 2007. I have enjoyed all these years on her. I even spent $7000 installing the Neville Lush Racing 200 HP kit and to go with it the 1.75" Paul Bryant Viking Exhuast. These mods really change the performance along...

Subject: Looking for HansO map – Rocket III Touring (De-restricting / Unlocking full power) Hi, I'm looking for a HansO map to de-restrict my Touring and open the secondary butterflies to 100%. Model: Triumph Rocket III Touring VIN: SMTC05LR78J346266 Engine Number: 3349665 Setup: K&N Filter...

Hello All, been a while. Had a strange thought that I was done with two wheeled machines then saw this: 2014 less than 2K miles. Came home today. Great to be back! Nice to see a number of familiar names still around.

3 X k&n and viking headers. o2 sensor disabled, speed limit 299kph, 7000rpm, secondaries 100% open, Use with 98 octane.. very little deceleration popping.. and decent fuel economy 👌

Have the Triumph factory accessories front bars. Looking for some front bar crash bar protectors (yes, I have dropped it). See a lot of 28mm items, but bars are around 32mm? What are you using? Thank you

Been looking at new Rockets since they came out, been on the fence for long time, mainly due to the price. Now that the used ones are hitting the market and are at my level, i may get one. How reliable are they? Any known issues? We just lost the Triumph dealership here in Tulsa, and the reason...

Does anyone know where these rings are available from, I had one many years ago and have mislaid it. I believe it came from Australia….. 🤔 Any help or leads are much appreciated.

Hello all, My name is Adam, and live in Fort Worth, TX. I just recently purchased a new to me 2023 Rocket 3 GT, which I reluctantly traded in my cherished 2020 Thruxton RS for. Here to learn more about the new beast, and glean some customization ideas from the rest of you. ;) Thanks in...