tuneecu

What TuneECU downloads are available for thr Roadster? I just installed the triple K&N’s yesterday. My next plan is to install the jardine header with pipe (that may or may not be open with no baffle) on the right side only. Thanks.

I have been informed that I am not charging enough for tuning with TuneEdit/TuneBoy or TuneECU. It seems that one of the members here has contacted a shop on the left coast of the USA about getting his R3 tuned with TuneECU. He was told that he would need to purchase a Power Commander and that...

Looking for a knowledgeable wrench out there to translate the following TuneBoy instructions to TuneECU equivalents. I need to replace my primary TPS tonight and don't want to screw it up.

Can't get it to work, anyone know what I am doing wrong? I have loaded the TuneEcu drivers, I have the key file in the folder with the TuneEcu.exe file. TuneEcu tells me it can't connect to bike to check connection then turn bike off and on. Any ideas????

At the request of your Moderator Team. Enjoy!

Since I have bought and paid for the Tuneboy software and cable, I should have the possibility to tune my Roadster using a dyno. however since Wayne at Tuneboy does not publish any base maps for the Roadster, so far the Tuneboy software is for me a scam. the license key is unique for my bike but...

Using a table like this one as a template recommended by Tuneboy for Air/Fuel-Ratio impovements do you think this might be a good table for the Roadster? 12.80 is known as the best ratio and I have leaned it in small steps depending on TP. the same ratio for all RPM is an idea from the...

Anyone keen on writing up a TuneECU tuneup guide for dummies? Id kick in some coin and Im sure other would to. Looks like there are lots of things to learn about before even going to the fuel maps. I started at "where is the ECU connection" :confused: Other things like the make up of...

Is there any program that can analyse datalogs from TuneECU like Megalogviewer?

Hi all Is the speedo correction in tuneECU v1.64 in km/hr or is it a percentage? Be fantastic if I could set it at -10.0 and have my speedo tell me Im doing 100 instead of 110 when Im really doing 100. Thanks

2005 R3 - TORS, cat delete, and K&N underseat filter - stock 20227 MAP Red - First run after warm up (baseline 1, blowing out the carbon) Blue - Second baseline with hot oil and cool engine (baseline 2) Green - Intermediate low end work. Yellow - Results from tuning. TuneECU - map: Rev...

I am very happy with my change of tune for the Roadster to open secondaries and new topspeed. the next thing I would like to do is to change the ignition tables to be the same all over. this is the same thing as installing a Gi PRO ATRE, although it does not exist for the Roadster yet. the...

Gents, I had the 020355 Tune uploaded from my Roadster. no problems. changed to 100% secondaries on all gear, all rpm. changed to new top speed. downloaded to the bike, no problem. turned ignition off, waited 10 seconds and turned on in order to reset TPS as described in the manual. I cannot...

Long time reader, first time poster. I am the guy that extracted the 020355.hex map for Roadster with TORS. My friend Niklas will provide the tune. http://www.r3owners.net/trading-tunes/7504-tuneecu-free-tuning-software-14.html although I usually post at our Swedish forum, r3owners.se, I did...

Now for a more complicated question. I'm currently running with stock intake and Staintune Exhaust w/ Cat delete. Current tune is Triumph 20226 (Aftermarket Exhaust w/ Cat delete). There exists a .dat file (Tuneboy) for the Staintune, Cat delete, full power, speedo correction. I believe...

TuneECU has a number of diagnostics and tests but, unfortunately, the user guide is a bit scant on procedures to use them. Can a Captain knowledgeable in these things help the developer out by going into more detail on each diagnostic and test? Please go into enough detail to prevent a shade...

To start this off, here's a simple topic. Assuming that the shade tree mechanic has the manifolds removed and is staring at the bare trottle bodies, how does one use TuneECU to balance the TBs?

Software and tunes - Link Removed Installation instructions in various languages - http://www.tomhamburg.net FTDI drivers - Virtual COM Port Drivers Cable - Link Removed Or try Ebay for cheaper prices. Simple over view: 1 - Download latest version of TuneECU. Unzip into new folder. 2...

For those that have debated about purchasing TuneBoy, your day has come. There is freeware available that is a close copy to TuneBoy, and operates on all Triumph triples. TuneECU v1.5.3 : Link Removed Download the software (unzip it into a specific file), the description, and the key -...