transmission noise!!

albertaduke said:

fred
I put back the gear position sensor but a doubt came over me !! the plug we bolt on can be mounted two ways 180 degrees from each position and I did not remember which way is right so I put it on with the connecting wire toward the middle of the rear of engine rather than on the outside figuring nobody would want the wire hanging around

Click to expand...

warp9.9 said:

Yes Patrick the wire harness goes on the inside pointing towards the center of the engine.

Click to expand...

albertaduke said:

wheelies must last 45 seconds to qualify as lubrication procedure!!

Click to expand...

albertaduke said:

thanks.. I am slowly buttoning her up , I have one loose electric connector that I have not found where is its match(picture 1239 zoom in to check what it is) and my rad covers are falling apart ,the cracks are everywhere old plastic I guess (picture 1240) will try an epoxy solution tomorrow. considering each part is about $75 , I am not buying plastic at this price

Click to expand...

Steel said:

I need practice then. I only go from 20 mph until I hit the rev limiter at 60 mph. I'll have to start trying to shift into 2nd.

Click to expand...