Help 2008 r3 touring not starting

[Wdugan9080]

On the throttle bodies you have three plugs/rubber caps
and you have 3 hoses all the same length that plugs into a 3-4 fitting( a plastic vac connector that has four connections) then the fourth one goes from tee to the map sensor i would say on throttle bodies that it does not matter witch vac hose goes where
on the coils you should check for the ignition 12 volts i think on the outer blade terminal if you have 12 on one of them then the other two should be fine because they are linked together
any small code reader should read codes but get the tuneecu like @atomsplitter said you will be glad you did

Thanks Turbo I don't have nor did I have plastic/rubber caps but all the fittings have a vacuum line. I know there's 2 vacuum hoses going up there from the evaporator, it just doesn't show the map sensor in the drawing in the manual and I think I have those lines switched, like I said the #3 throttle body has 3 vacuum fittings, I'll check the coils, I guess just key on in neutral with clutch lever pulled in should give me battery voltage at the coil right? And I have both scanners so I'll try the obd2 scanner instead of tune ecu cause it much easier to get together. I just thought there's a different light than the check engine that comes on for a stored code and didn't think it would read the ecu without it running. But I'll try that first, thanks again and for getting back to me so quickly.