I would see this being useful for stepper motor but not really TPS.
I reset adaptations again today and balanced the throttle bodies as best I could. It was a little tough because the idle is not perfectly steady. They where off by 20-30. No 1 and 2 are right on and 3 is low by 10 but bounces to even also.
I also reset ISCV and stepper motor. No difference.
Went about 40 miles today. Bike is running excellent other than the idle not holding perfectly steady. May just be more a result of the tune. I haven’t checked the gap on the stepper motor yet. Project for another day. Also probably going to spray some ether around to check for a vacuum leak. Hoses look fairly new from what I can see though. Triumph really didn’t tidy up the wires and hoses well under the tank.