Claviger
Reaction score
12,293

Profile posts Latest activity Postings Media Albums Resources About Post areas

  • Question? I have a 2016 Roadster, with DPlatt crossover and slip on mufflers. Just added a ramair last week also. So, I downloaded Hanso's tune 20776 3rd generation, unrestricted, 2014+ Roadster TORS, triple filter/ Ramair etc. I noticed on this tune the O2 sensor is not enabled, but still installed and connected. What is the right approach, enabled or disabled?
    Good afternoon sir. I have installed the 20368 tune that you provided on the site. The bike runs great!! I used my android phone to install it. Do you remember the last time you tuned the bike when it was still Mike's bike if you changed the redline to 6500? It is still the same as it was before I installed the 20368 tune. It hits the limiter at 80mph in 2nd gear....
    Hey Clavinger I have the 240 package and the sidewinder exhaust. With the map that Bob installed in the PC I notice that the bike has a hesitation if I twist hard on the throttle when below 3000 rpms. This is especially true in 3,4,5 gears. If it is correctable would you be willing to lend your expeetise?
    Claviger
    Claviger
    I'd take it you a local shop to get a Dyno test done and get a print out with AFR showing, just as a first step troubleshooting. Without it, everything is just a shot in the wind so to speak trying to fix it.
    Clavinger . just picked up a 18 rocket roadster. was looking to install ramair, carpenter sidewinder. i see your input on the tuneboy. what would you recommend for a tuning device I am just getting to know that beast of a machine and the aftermarket world of the rocket. any help will be greatly appreciated. Thanks .
    I was looking at an older post with the coil over plug mod, did you wire them in series, or did you wire them normally?
    Claviger
    Claviger
    I wired them in parallel, exactly as Neville described doing.
    crashpete
    crashpete
    Roger that, thanks for the info, good thing that I asked! I thought series was the way to go.
    Claviger, Because I'm looking for a increasing rpm ecu mapping for my Roadster 2010, Scott (Warp) informed me you did get a 8/9000rpm ecu tunemapping from Carpenter ?
    My OEM injectors are reading 11.9 ohms which is out of the specs in the maintenance manual. I read that you replaced your OEM injectors with aftermarket. If you still have the originals, could you please measure the resistance and see if your OEMs are close to mine? Thanks, Lee.
    Thanks for the tune. Not anywhere ready to download to the bike but it is nice to know that when I do finish the work we already have a tune ready. THANKS AGAIN>
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Back
Top