Pig9r
Living Legend
You can to cant them forword. Toystoretom runs a set of them. I think he accidentally sucked a cat into one of the TB's.
Coolant Overflow Tank
- Thread starter flhtpi
- Start date
warp9.9
Pocałuj mnie w dupę
nice head light work can you tell us about then busajack?
xhdskip
Living Legend
Spike was definetly one of a kind.
warp they are just the old time cat eye covers.. JP cycles has them, let me see if I can find them.
Heres a set. Most of the street rod places have them.D & S Rod and Custom - Cat Eye Headlight Cover (Powered by CubeCart)
Got these from JP but cant find them on their site.
Last edited:
tdragger
Living Legend
I located the tank and cap (8787 and 8929) but I can't seem to locate the pickups and fittings. Can you point me to the correct page?
dragline708
Supercharged
Theses will fit under bear claw AND YOU DON'T HAVE TO
MOVE OVER FLOW TANK , I am using them now
Any of these part numbers will fit
UP 4245ST ID 2.5 OD 4'' LENGTH 4"
UP4245AST ID 2.5 OD 4'" LENGTH 4" < ANGLE
UP4245 ID 2.5 OD 3.5 LENGTH 4 "
UP4245 S ID 2.5 OD 3.5 LENGTH 4 "
They have spring inside & they are foam , so they bend
ANGLED OR STRAIGHT
You have to oil them very lightly
3 in 1 oil works fine
You will have to press down while you tighten clamp
OR they pop off since throttle bodies don't have much of a lip
on them
Once tightened firm ( not overly tighten )
They are very smug !
New one's ON and working fine
The above I purchased yesterday , they have rubber base cup ( have spring also )
and they use a clamp , actually like them better
Picture below , was older model
That you had to use a plastic tie wrap
to hold them on
Link Removed
Link Removed
Wayne
MOVE OVER FLOW TANK , I am using them now
Any of these part numbers will fit
UP 4245ST ID 2.5 OD 4'' LENGTH 4"
UP4245AST ID 2.5 OD 4'" LENGTH 4" < ANGLE
UP4245 ID 2.5 OD 3.5 LENGTH 4 "
UP4245 S ID 2.5 OD 3.5 LENGTH 4 "
They have spring inside & they are foam , so they bend
ANGLED OR STRAIGHT
You have to oil them very lightly
3 in 1 oil works fine
You will have to press down while you tighten clamp
OR they pop off since throttle bodies don't have much of a lip
on them
Once tightened firm ( not overly tighten )
They are very smug !
New one's ON and working fine
The above I purchased yesterday , they have rubber base cup ( have spring also )
and they use a clamp , actually like them better
Picture below , was older model
That you had to use a plastic tie wrap
to hold them on
Link Removed
Link Removed
Wayne
2300XXL
.040 Over
Overflow tank
Any suggestion on a replacement -clearer tank - that fits, where the OE overflow tank is mounted. I think the OE grayish colour does not allow for easy inspection
Any suggestion on a replacement -clearer tank - that fits, where the OE overflow tank is mounted. I think the OE grayish colour does not allow for easy inspection
