Bearclaw cutting

EasTexRIII said:

Draw the line for your cut with a black marker. Cover the area you want saved with duct tape for protection. Take a disk type cut off wheel and cut through the metal about a 1/8 inch shy of your mark line because the line will be a little bit straight at each cut section. After you cut the lower part off you can then take a grinding stone to shape your curve. After you get your cut rounded, go to auto parts store and buy a strip of door edge molding to dress it up and cover up sharp edge.

Click to expand...

Jonathan Nikolaisen said:

Awesome, thank you. Cones mounted and going to try to make nice cuts...

Click to expand...

CrzystghndKC said:

I got rid of the OEM overflow tank and mounted one to my crash bar. This allows plenty of air flow behind the claw without cutting it up.

Click to expand...

CrzystghndKC said:

You can buy these on Fleabay for about $20. Polished stainless

Click to expand...

Jonathan Nikolaisen said:

That chrome cylinder is your overflow?!

Click to expand...

Jonathan Nikolaisen said:

That chrome cylinder is your overflow?!

Click to expand...

CrzystghndKC said:

Yes

Click to expand...