Tune ECU / PCV help

[Pedro]

when you tried to change the PC map did you save it to a different name ,if so go back to that map and install in PC.

 

[Steel]

I never saved what was in it. I just went back to the zero map.

 

[Pedro]

if you click get map, the 0 map comes up ,yes.and you did send the map to the PC.

you could down load the 00 map name it different and try installing it again just in case you have corrupted the other one you had.

 

[Steel]

I did reload the zero map, it didn't work. I also tried Hanso's original map, but it's not helping either.

 

[Pedro]

Sorry i was no help, Just start over,put the tune you had in the ecu before you made changes and when it was running well.
You will get it sorted.

 

[Tom-Hamburg]

If your R3R a real model 2012 is (model up to VIN # 574812), use the map for the production silencer (20352), for the aftermarket silencers e.g. TORS, please use the map 20355.

Now load the PC-V zerro-map on the Power Commander-V.

Now put the adaptation with TuneECU back and start the engine, let the motor run at idle until the green "TPS light" in TuneECU appears. In this process, do not touch the throttle.

If you reset the Adaption want to perform with the 12 Mintuten Tune, they proceed as follows:
1. Ensure the transmission is in neutral.
2. Ensure the ECM has no stored faults (DTCs).
3. WITHOUT TOUCHING THE THROTTLE, start the engine and allow it to warm up to 90°C (Coolant temperature) .
4. Leave the engine to idle for a further 12 minutes. Now have fun.

Does your bike a VIN greater as 574812, then it is a model 2013.
For this model with production silencer, the map "20685" is required.
For this model with aftermarket silencers e.g. TORS, the map "20688" is required.

Download sources:

PC-V zerro map: http://www.powercommander.com/downloads/21-003/maps/M21-003-000.pvm

20352map: http://www.tuneecu.com/Tunes_in_Hex...model/all_Rocket/Rocket_Roadster/20352Map.zip

20355map: http://www.tuneecu.com/Tunes_in_Hex...model/all_Rocket/Rocket_Roadster/20355Map.zip

20685map: http://www.tuneecu.com/Tunes_in_Hex.../Rocket_Roadster_from_VIN 574813/20685Map.zip

20688map: http://www.tuneecu.com/Tunes_in_Hex.../Rocket_Roadster_from_VIN 574813/20688Map.zip

I hope it helps you.

BR, Tom

 

[barbagris]

Great reply from Tom.

Hanso has a 2008 R3 - If he's sent you the map from his bike and if you've put that map into a 2012 roadster Triumph ECU - there is no way it will work.

 

[Steel]

I have a code P0335 Crankshaft sensor malfunction.

The bike won't start at all

 

[barbagris]

If it's still under warranty - get thee to your dealer.

BUT if it were me I'd put the ORIGINAL TRIUMPH MAP BACK IN and remove the PCV before you call them.

 

[Steel]

I guess I'll have to bring her in. But without the PC, I'd have to put all the air plumbing back in