Rebuilding motorcycle after timing chain skip 62K Km

Claudiu said:
Tensioner blade plastic slide disconnected. I am chasing a rattle on hot start since four years. Will see if this was the cause when I will start the engine.
Click to expand...
Is the bike living in your car? I sure hope you remember how it all came apart...
 
You roll circlips in one spiral at a time, always had piston in my hand or on table when installing circlips.
 
3-D said:
Is the bike living in your car? I sure hope you remember how it all came apart...
Click to expand...
It moved into the garage, cupboards and boxes . I built myself worksheets and instructions. With pictures and hand notes. But the most annoying is that the bolts and nuts are together…
 
Gerald said:
You roll circlips in one spiral at a time, always had piston in my hand or on table when installing circlips.
Click to expand...
In this version of events I left the conrods on the crankshaft to avoid splitting the crankcase. I can install one circlip and the piston rings on the table, then the pistons go into the barrel and I lower the barrel to fit the gudgeon pins and the second circlip for each piston. I need three hands, a thin tentacle and a makeshift overhead crane… or more tentacles
 
You must log in or register to reply here.

Similar threads

Rocket 3 GT oil leak after 6000 km
Replies
4
Views
1K
RockMad
My 5,000 km road trip report
Replies
4
Views
706
HarryBo
Problems after tuning or coincidence?
Replies
6
Views
707
Eugene IT.
Differential oil after 2000 miles
Replies
9
Views
1K
Idaho Red Rocket 3
DIY - Valve check/adjust; timing; clutch change; fuel and air filter; spark plug change maintenance....
2 3
Replies
26
Views
3K
Slo1
Menu
Log in
Register