Ramair filter IAT sensor hole size ?

Discussion in 'Rocket Performance' started by ant, Oct 3, 2019.

  1. ant

    ant Turbocharged

    Country:
    United Kingdom
    Messages:
    541
    Featured Threads:
    8
    Likes Received:
    271
    Trophy Points:
    73
    Location:
    West Sussex UK
    Ride:
    Triumph rocket 3 2007
    I have been trying to purchase a rubber washer as shown on the parts list.Ramair are saying that the
    hole for the IAT sensor on the early filters were a larger hole and that was the reason for the washer.

    Is there anyone that knows for sure if only the early filters used the washers..I think the early filters had
    a problem with cracking. WP_20190825_004.jpg
     
  2. Nat67

    Nat67 Rockgoblin

    Country:
    United Kingdom
    Messages:
    4,092
    Featured Threads:
    17
    Likes Received:
    7,497
    Trophy Points:
    823
    Location:
    Dartmoor England
    Ride:
    Rocket 3 2010 roadster
    If you use some self amalganating rubber tape , you can wrap it around the sensor until you get a nice tight fit ! when you refit the bear claw, put a couple of small washers behind the mounting tab at the rear of the tank . this will help stop the foam of the Ramair chafeing against the bear claw , or some self adhesive reflective foamed foil . the type you put behind household radiators to reflect the heat . stuck to the inside rear of the bear claw ., will do the same thing . with the bear claw in place , it touches the foam on the number 3 throttle body and vibration does a good job of fubaring it !
     
Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice