Ok here goes, sorry if I miss anything, I’ll try not to.
1: Put down a drip pan under the water pump.
2: Remove only the top of the three bolts on the water pump to drain it. Once flowing remove radiator cap to speed it up.
3: Remove all shrouds and mesh screen.
4: Remove lower radiator hose going to water pump.
5: Reinstall top water pump bolt.
6: Remove top two bolts holding radiator to frame.
7: Remove upper radiator hose from radiator. Leave engine side alone.
8: Remove small hose on throttle side of bike on back side of radiator (thermostat bypass hose). Leave engine side alone.
9: Remove two bolts at top of fan securing it to radiator and one on the bottom holding fan to radiator.
10: Remove over flow hose from radiator just below rad cap.
11: Remove bottom mount bolt. 8mm socket and 18” or great extension is your friend.
12: Remove rad from bike.
13: Have a beer.
14: Reverse process, except start with upper radiator hose so it hangs from it, it beats trying to hold it in place while doing all the mounting work. Once radiator is fully mounted proceed to step -5.
15: Remove 10mm Bolt from above Thermostat house.
16: Level bike.
17: Fill radiator until water flows out of 10mm hole above thermostat housing.
18: Reinstal 10mm Bolt.
19: start bike with cap off and level. Fill radiator full.
20: Install radiator cap.
21: Ride on!