CES Header & Crossover pipe

[ThingKing]

Yes I just got a email from Neville stating that after speaking with Trevor, there will have to be a couple of cuts made, going to go see Neville tomorrow and get some pictures etc, but its looking like the "jig" for making the crossover may have been out.
Following is part of the email Neville sent me...... "I am confident of it fitting with some mods. Trevor has given me the go ahead to do this. They have never done a big bore crossover before, so did it off the jig, which is obviously not correct. I need to carefully shorten the header and alter part of the crossover."
I trust Neville's assessment and am sure it will get sorted, just going to take abit longer than anticipated for something that should have basically been "plug and play".

Well they did my big bore crossover a few months ago. It should be exactly the same as yours.

If I remember correctly, my mechanic finally cut about one inch off the end of the header pipe to make the whole combo fit to the bike.
Since I knew my order was different from their regular product line, i filed any difficulties under "my stuff has always been and always will be a pain for the mechanics, that's business as usual".

Now I'm using circumcised headers, which means longer and safer pleasure...

 

[Mike188]

Well they did my big bore crossover a few months ago. It should be exactly the same as yours.

If I remember correctly, my mechanic finally cut about one inch off the end of the header pipe to make the whole combo fit to the bike.
Since I knew my order was different from their regular product line, i filed any difficulties under "my stuff has always been and always will be a pain for the mechanics, that's business as usual".

Now I'm using circumcised headers, which means longer and safer pleasure...

LOL
yep that's what Neville told me also, headers about 30mm to long...................

 

[cusso ken]

LOL
yep that's what Neville told me also, headers about 30mm to long...................

That's not as bad as being 30mm too short, on truck turbo dump pipes because the engines go into various models the pipes are purposely made long so they can be trimmed for the final fit ,but I wouldn't have expected it to be the case with a simple model specific motorcycle exhaust system, I hope it is as simple as a bit of foreskin trim.

 

[Mike188]

That's not as bad as being 30mm too short,but I wouldn't have expected it to be the case with a simple model specific motorcycle exhaust system, I hope it is as simple as a bit of foreskin trim.

That makes 2 of us Ken

 

[Mike188]

As far as we have got, just wish the whole thing was finished

 

[1olbull]

As far as we have got, just wish the whole thing was finished

A work of art to be sure!
GREAT exhaust system!
I just wish mine still looked that shiny.
Note: These are diirty as I just returned from a 2500 mile ride to @RKTNMYPKT in CA.

 

[Mike188]

I got an email from Neville tonight, and the bike is finally ready, pity I can't pick it up till Monday. Still worth the wait, got a gain in HP and torque across the rev range..... Will post a couple of pictures once the beast is home

 

[Mike188]

Finally have The Beast home, all done, sounds a little bit deeper/louder. Here are a couple of pictures, and the dyno chart
Many thanks to Neville Lush for the work that he had top put in to make it all happen.

 

[LOFTYBOB]

Not only do you have the same bike as me, and live in the same town as me, you have the same bloody bike rug as me.

Stop stalking me.

 

[Mike188]

Not only do you have the same bike as me, and live in the same town as me, you have the same bloody bike rug as me.

Stop stalking me.

I don't have the white go fast stripes