Upgrade Flyscreen to clear shield

[Busaboy]

Is there a larger clear windscreen screen available that will mount using my existing Flyscreen hardware and fork mounts? The other option is a clear windscreen that can use the existing fork mounts. I would like to deflect the wind above my head.

 

[Mark Dunn]

Hi Busaboy,

How tall are you? I'm 6'1" and have the Triumph 'Roadster' clear screen which pushes the wind just over the top of my helmet. It works well for me but some prefer a screen a little taller and/or wider.

Regards,
Mark Dunn

 

[Busaboy]

Hi Busaboy,

How tall are you? I'm 6'1" and have the Triumph 'Roadster' clear screen which pushes the wind just over the top of my helmet. It works well for me but some prefer a screen a little taller and/or wider.

Regards,
Mark Dunn

I'm 5'10". The Flyscreen directs air into my face. Its OK if I wear a full face helmet. FL is a no helmet state. I detest getting sand in my eyes so I prefer a screen that blocks most of the blast. I would like to at least reuse the "stock" fork mounts. That way I can swap screens more easily.

The Roadster screen I have seen looks a bit low. Is it 23" wide by 18" tall? Does it use the Flyscreen fork mounts? Is it the pic below?

 

[Mark Dunn]

I'm not sure if it uses the same fork mounts as I've never owned a fly screen. Someone else will chime in shortly, I'm sure.

The Roadster screen is approximately 19.5" tall measured from the tip of the 'peak' between the headlight cutouts and the top, and around 25" wide measured across the middle.

Regards,
Mark Dunn

 

[Gregger]

The flyscreen and windshield use the same fork mounts. I swap mine out regularly.

 

[1olbull]

Your height has little to do with sizing your shield!
What is important and varies much person to person, is your seated eye height.
I am 5' 10", but my seated eye height is 33". This is taller than many over 6' tall.

 

[FunkSoulBro]

I'm 5'10". The Flyscreen directs air into my face. Its OK if I wear a full face helmet. FL is a no helmet state. I detest getting sand in my eyes so I prefer a screen that blocks most of the blast. I would like to at least reuse the "stock" fork mounts. That way I can swap screens more easily.

The Roadster screen I have seen looks a bit low. Is it 23" wide by 18" tall? Does it use the Flyscreen fork mounts? Is it the pic below?

That looks familiar...

 

[FunkSoulBro]

You will need the 2 brackets as shown in the pic to move the summer screen forward. These brackets mount directly on to the fork mounts.

 

[Busaboy]

That looks familiar...

You take good photos