Terryfyd
.020 Over
Hello all! I have a 2005 Rocket, I upgraded the lifter piece, the bearing and of course the pressure plate to accommodate the thicker ball bearing. I see that the thrust washer (#19) is no longer needed with this assembly "Eng no 249177 - fitted with T3800082, needle bearing. NOT required with T1170067, deep groove bearing" and the regular washer (#27) is only sometimes needed. " Eng No 369111; Fitted with T1170029, T1170057 & T1170059 (issue1). NOT required with T1170059 (issue 2), T1170159 or T1172023 lifter pieces dut to 4.1mm shoulder width". Am I correct in assuming that the spacer (#23) and wavy washer (#3) are needed. The washer and wavy washer will not fit over the lifter piece as shown in the old diagram. Is there a clutch assembly diagram that I can refer to with the upgraded lifter piece and bearing. Even the 2022 diagrams are still showing the old needle bearing. Any insight would be appreciated. Thanks in advance!