After a few weeks of messing around and pulling out the little bit of my remaining hair, I figured out why my cable/software didn't connect to the ecu.
On my bike the headlight fuse also controls the instrument cluster. So the program must be sensing an error with the fuse out - since it can see the tach and speedo this makes sense - so I tried it with the fuse in and it hooked up immediately....
After a few weeks of messing around and pulling out the little bit of my remaining hair, I figured out why my cable/software didn't connect to the ecu.
On my bike the headlight fuse also controls the instrument cluster. So the program must be sensing an error with the fuse out - since it can see the tach and speedo this makes sense - so I tried it with the fuse in and it hooked up immediately....
Being ignorant of the whole process - everywhere I looked it said to take the stupid fuse out....I used a trickle anyway - the process was so quick it wouldn't have mattered
Quick question....I downloaded hanso's map to the bike the number is 20776 . When I read the map on the bike it shows as 20773 but the information on the map is hanso'so. Just making sure the correct map is installed....does this sound ok?