Passenger footrest risers?

xlr8tion

Turbocharged
Joined
Jan 13, 2016
Messages
509
Location
Aiken, South Carolina
Ride
2016 BMW S1000XR
Hey Guys.....

My Rivco passenger rests are about 3/8" from touching the top stock pipe on the R side....Does anyone of a set of adapters that move the footrests up and or away from the OEM pipe. Putting a D and D 3-2 exhaust would be a problem as they have a slight upward rake and I do not think they would clear the footrests....

Thanks!

Greg
 

Attachments

  • 1-Rocket1.jpg
    52.4 KB · Views: 8
  • 1-Rocket1.jpg
    55.7 KB · Views: 7
I believe when you install the D&D pipes you will have a little more clearance because the outside diameter of the D&D pipes is a little smaller than the OEM pipes by 10 mm or more.
 
I believe when you install the D&D pipes you will have a little more clearance because the outside diameter of the D&D pipes is a little smaller than the OEM pipes by 10 mm or more.


Thanks Bill....

I was more concerned about the upward angle of incidence.....The oem have less "Upward Cant" than the D and D's. Did you take a close look how close, in my pics, that the Rivcos come to the upper pipe/

Thanks....

G
 
From the looks of it you do not have the rivco relocation arms which also extend the floor boards forward and up a little bit. Don't let your passenger know or you will be buying them.
 
Look at this picture closely and you will see how much extra clearance room there is between the passenger peg mount and the D&D pipes. I think your Rivco boards will be fine. There looks to be a full inch or more of clearance. If that isn't enough to ease your worries then of course you can always get the Rivco Relocation Arms like I have.

 


Thanks Bill..you always come through! Looks like it would fit! You da' man again!

Warp...my wife if 5 foot tall so they are fine...

Cheers...G
 
I made a relocation bracket a few years back out of some 1/8" bar. It was not that difficult, even with my limited manufacturing abilities.