My Bear Claw

cane corso

Turbocharged
Joined
Apr 4, 2006
Messages
655
Location
Canada, Toronto
Ride
05 Triumph rocket 111
This is my Bear claw - it's just primed.
I made it cover the bottom of the filters, and there is a lot more room so a bigger filter could go in, or if I decide to go Turbo this will cover it.
I noticed when guys go turbo they ended up cutting out the bear claw .
And it fits a lot nicer then the original bear claw. Each vent is where each of the filters are to get more air and give it a little more aggressive look.
I'm holding up it because I have not figured out the brackets. I can't position the same brackets since this is larger and deeper. I think it's going to be a pain in the butt to figure out.
 

Attachments

  • DSCF7530.jpg
    122.2 KB · Views: 219
Make it bigger still and call it a fairing .... You will know you have gone too far when the engine is covered completely. lol

What did you make it out of? Almost looks like you combined more than one material.
 
Last edited:
Hell Fire its not that much bigger it's about a half inch wider so it will cover the bottom of filters, and it wraps more around the front and the top roundness is the same and and it bubbles out again giveing more room around the filters, its about inch in a half away from filters.
I used wood and fiberglass and bought the metal louvers, I cheated
 
No its not on need to do the mounting .
I don't think it will make noise with the vents plenty of air could excape from bottom.
I have vents on my spoiler and on my bottom cover has vent on the bottom and there is no wind noise.
 
Last edited:
You must log in or register to reply here.

Similar threads

Motor Trike conversion for my 2016 Rocket III
2
Replies
18
Views
2K
Gerald
Bear attack
Replies
7
Views
999
2012cliff
Slip on exhaust anyone can do (How i fixed up my rashed out stock pipes)
Replies
3
Views
1K
Mongler07
My Rocket glide, custom, work in progress.
2
Replies
15
Views
2K
RazMan
My Bearclaw Mod
2 3
Replies
27
Views
5K
vindex1963
Menu
Log in
Register