How to make Rocket exhaust flanges.

[Doc Roc]

I made a former from some round bar with lumps added to the side. Then got some scaffold tube and machined the galvanising off it. Heat it up red hot and press former into it. Removed former put pipe in lathe and machined the flange end square, cut to length and TAA DAA a flange.

 

[owl]

I'll just go out to my shed and knock one up then.

 

[xhdskip]

looks like a good start on your exhaust project.
Two more and you're ready to begin.
come to think of it, you better do up several sets of three,
might not work out the first time round.
but good luck never the less, and can't wait to see what you come up with.

 

[barbagris]

come to think of it, you better do up several sets of three,
might not work out the first time round.

OR! - in case anybody else wants a set.

 

[HansO]

Well done Simple but efective Why the Sacffod tube is a higher strenght or ? just curious

 

[Blastedbones]

Go back out & do it in stainless!!




Seriously tho.. wow!!:shock: :RockOn:

 

[Doc Roc]

Send me the stainless. I'm using scaff tube because I have heaps of it to experiment with and because I can!

 

[Trirocket3]

Send me the stainless. I'm using scaff tube because I have heaps of it to experiment with and because I can!

Good answer

 

[HansO]

Send me the stainless. I'm using scaff tube because I have heaps of it to experiment with and because I can!

cool, like a man that don't waste , I only was asking cos I was curious as to if it had some superior qualities

 

[hogweed]

Thats the shinniest scaffold tube i've ever seen.