heil_7134
.020 Over
so i was working with my bike, 06 classic few days ago and suddenly tune ecu wont detect the ecm, i tried turning the key off and on and kill switch to run and theres the usual gauge sweep but i noticed the fuel pump didnt prime, the stepper motor and secondary didnt move, when i pressed starter nothing happened. theres a check engine light and the oil pressure light on the panel, theres no way i can check the error code since tuneecu wont recognize the ecm. i already did the ignition switch fix few months ago and already did the headlight relay mod so ignition switch problem might be out of the equation.
i already checked the alarm bypass connector and found out that only pins 2,4 and 6 has 12v.
also my speedometer quit working a while back but the tachometer is still working, itll only sweeps after i start the bike, but this time since the problem started, the tachometer sweeps right after i turn the killswitch to on. relays on the left side of the seat has been swapped to eliminate relay problems, still no positive outcome, battery is in tiptop condition and always been on battery tender while working on the bike.
i already checked the alarm bypass connector and found out that only pins 2,4 and 6 has 12v.
also my speedometer quit working a while back but the tachometer is still working, itll only sweeps after i start the bike, but this time since the problem started, the tachometer sweeps right after i turn the killswitch to on. relays on the left side of the seat has been swapped to eliminate relay problems, still no positive outcome, battery is in tiptop condition and always been on battery tender while working on the bike.