ECM Connectors

leatal

Turbocharged
Joined
Mar 11, 2015
Messages
847
Location
Dothan, Alabama
Ride
2014 Roadster, 2020 Rocket GT
Anyone know where I can get both the gray and black locking tab connectors for the ECM? Went to remove my ECM and discovered the dealer I purchased the bike from had swapped out the ECM and in the process broke both locking tabs. I have been operating the bike for over two years with the connectors plugged in but not locked in!
 
GULP _ Good luck mate.
Stick it to the dealer.....
 
One still had the broken locking tab under the rubber cover. The other tab was missing. I did attach the connectors using silicon. Will also add a zip tie for extra security. I just prefer to have it as original rather than hodgepodge it to work.
 
+3 on zip ties. If the dealer can't get the connector apart without breaking it then I wouldn't trust them to take the pins out and reinstall them again.
 
+1
by the time u get through messing with it u could have the pins opened up causing lots of problems. and if the pins close up then when u push it into the ecu u might damage the ecu.
nothing wrong with some plastic ties.
 
You must log in or register to reply here.

Similar threads

Turn signal connectors?
Replies
3
Views
976
Bikefalcon
2005 STALLING, NO ECM DATA WHEN RUNNING. UPDATED
2
Replies
14
Views
2K
skydog1000
AIT Connectors
Replies
6
Views
969
SMLWNKR
Re-mapping ECM
Replies
1
Views
436
CrzystghndKC
Does reversing the battery polarity blow the ECM
2 3 4
Replies
30
Views
6K
warp9.9
Menu
Log in
Register