DP exhaust... that's fast!

Fool to Ride said:
I used PBs viking exhaust. He'll fabricate pretty much whatever you want. I went with single slip on. Good look and sound. Cut alot of wait tsking off old pipes.
Click to expand...

That there is a very sweet looking can!
BUT, will it hook up when you get Paul's header???
 
Dp shorties great sound install within an hour if I had the wonga would have another set for the coffee table like a piece of art ....
 
The Carpenter Brute pipe I just put on my Classic with stock motor made 167 hp. With bone stock Rockets making 120-125 hp on average, even if I started on the higher side (125) it would have gained 42 hp. It definitely feels much stronger than before.
 
The stock headers are a bottleneck. My power and torque jumped with the Jardine headers and Thugs.
 
I just took my first ride with them on a few days ago! I tell you! The music coming out of this thing is insane! Bit high on the decel popping but once the tune is on it should be good! Love em!
 
Senadin said:
I just took my first ride with them on a few days ago! I tell you! The music coming out of this thing is insane! Bit high on the decel popping but once the tune is on it should be good! Love em!
Click to expand...

I found that if you throttle back rather than throttle off, you can control the decel pop
 
Mine did not come with instructions either, but was easy to just replace the existing hardwar and hangers with the DPs stuff. You only need one crush washer at the header crossover junction, the remainder are slip joints. I used manifold gasket paste on all joints, cured it whilst the 12 minute tune was occurring so it did not blow out on first ride
 
These pipes do NOT come with any form of written/printed instructions for assembly or installation. The best I managed to get was this from the 'manufacturer'

So from memory,

Strip the exhaust back to the down pipe joint.

Fit the cross pipe and mount loosely.

Bolt loosely the right hand side new bracket.

Offer the left hand pipe up and push on to the cross pipe.

Mount the two screws on the stock bracket.

Mount the RHS pipe on the cross pipe and insert the two mounting screws.

Finger tighten all screws and bolts.

Tighten the down pipe joint.

Tighten the cross pipe clamps.

Tighten the silencer clamps

Tighten the mounting bolts.


Start the engine and leave on tickover for 12 minutes and wait until the fan kicks in.

Goes off and come in again

The ECU will re map to suit, however for you and the Zard you could well have the custom map already installed which will be ok for this system.


Good luck cos you might need it!!
 
Indeed, it was the only seal included. He forgot to send the clamps, bolts, and any other fittings... Personally I had a nightmare getting this system fitted - never again
Looking to replace the whole system with something made a little more professionally... @Paul Bryant
 
You must log in or register to reply here.

Similar threads

2011 R3R Ramair & Viking Exhaust Dyno Results
2
Replies
18
Views
4K
phar2slo
That's it!!
2
Replies
14
Views
2K
2012cliff
Fastest motorcycle run ever: 268 mph at Virginia NHRA Nationals
Replies
0
Views
685
Journeyman
Viking exhaust
2
Replies
14
Views
2K
Waconut
Christmas came early this year...Viking exhaust recieved
2
Replies
10
Views
2K
canecorso
Menu
Log in
Register