Crankshaft position sensor

Mike Rocket

Rocket 3
Joined
Oct 27, 2017
Messages
739
Location
East Anglia, England
Ride
2014 Rocket 3 Roadster
Can somebody confirm where the crankshaft position sensor is on the rocket 3?
Is it the sensor underneath the sump towards the rear with just the one fixing bolt?
Or even better show a picture of it. It's not clear to me in the manual I have.
Thanks
 
Mike Rocket said:
Can somebody confirm where the crankshaft position sensor is on the rocket 3?
Is it the sensor underneath the sump towards the rear with just the one fixing bolt?
Or even better show a picture of it. It's not clear to me in the manual I have.
Thanks
Click to expand...

Thankyou
 
scot in exile said:
If you still need a picture I can get one for you later on but someone will probably post one soon.
Click to expand...

Thanks for that. I have the official manual but am still having trouble confirming it.
if it is the sensor that hangs down in a vertical position towards the rear of the sump plate with just the one bolt holding it I think I can see it. It has a cable on it that comes off the bottom of it at 90 degrees and then goes up behind the engine somewhere.
Am I correct ?
Thanks for you advice.
 
warp9.9 said:
Here you go make sure you look at it first to see if any and what the debris is and use a rag that doesn't leave fuzzy lint on it.

Click to expand...

Thank you very much for the photograph and advice. So much better than the manual I have. (and it's the official Triumph manual)
 
Gregger said:
Hey @warp9.9 what is the hose in the picture with the petcock attached for? Just curious?
Click to expand...
I don't use a crank case filter like most of the modifications. Mine vapors go thru a baffled oil catch can. that has one way vacuum operated valve that opens when the engine is running my Vapors after they have been filtered are drawn out the exhaust. That is a tell Tail/easy way of emptying the can of any vapor/liquid that is filtered. Also If I have any Piston problems I will notice it there.
 
warp9.9 said:
Here you go make sure you look at it first to see if any and what the debris is and use a rag that doesn't leave fuzzy lint on it.

Click to expand...
Do you have a picture of where the wire attached goes to? Recently put the upgrade gear position sensor through that sob of a hole.
 
You must log in or register to reply here.

Similar threads

MAP and or Air Pressure sensor fault
2 3
Replies
21
Views
561
atomsplitter
O2 Sensor Thread Size?
Replies
6
Views
341
TURBO200R4
Gear position sensor 2014 roadster
2 3
Replies
23
Views
2K
TURBO200R4
Gear position sensor
Replies
6
Views
1K
CrzystghndKC
K&N 3 filter swap, AIT sensor
Replies
5
Views
702
MtlSteve
Menu
Log in
Register