Replacing TPS

[1olbull]

beats me i have only used with vista lap top.

'Spose some research is in order for me, Amigo.

 

[EasTexRIII]

'Spose some research is in order for me, Amigo.

I do all the changes with android tablet. Since you are going through the cable, when the box pops up asking if you want to allow Bluetooth, you hafta click NO or it won't allow you to make changes. It won't make changes via Bluetooth.

 

[1olbull]

I do all the changes with android tablet. Since you are going through the cable, when the box pops up asking if you want to allow Bluetooth, you hafta click NO or it won't allow you to make changes. It won't make changes via Bluetooth.

That there is what I thought!
Thanks for confirming, Amigo!

 

[motolink]

I recently replaced the primary TPS on my Roadster, I read up on it plus got a lot of help from the captains on this site and really it turned out to be easier than I thought.
I have tunes ECU.
I guess I checked the voltage two or three times after fitting the new one just to be sure.
In the end it was not my problem, I found the two primary wires on the coils were very loose, crimped them to make a tight fit on the coils and all has been well since.

 

[vocaldog]

THANK YOU!! I'm gonna take all your recommendations and post pics of my epic fall ride for you!!

I had some trouble, but I finally got the Tune ECU to hook up! It says I am running map 20055 and that my speed sensor circuit is malfunctioning. Could that be why it intermittently runs VERY rough at both idle and at speed? Does the bike have to be running for that info to come up? Ignition is on and kill switch is in 'run' position. Now, I just have to figure out how to save and load maps Thanks again!

 

[warp9.9]

I'd copy the tune and clear the code to see if it was just a burp. it wouldn't hurt to run a ISCV RESET to check the tps that is in it since you have a speed sensor code.

 

[vocaldog]

I'd copy the tune and clear the code to see if it was just a burp. it wouldn't hurt to run a ISCV RESET to check the tps that is in it since you have a speed sensor code.

Thanks. How do I run the ISCV reset?

 

[warp9.9]

Thanks. How do I run the ISCV reset?

PDF is on this link
http://www.tomhamburg.net/Tunes_in_...C_Stepper_Adjustment_A4Rev_02_20120204_EN.pdf

This is just like the sprint only the sprint TPS has two bolts and is a pain to get at compared to the Rocket.

I am not up on the phone apps but bet it has a test/adjust section or tab like the normal computer program.
Other phone app experts will be along to share their knowledge.
I also found this on the android stuff that might be helpful to you.
http://www.tomhamburg.net/Tunes_in_Hex_and_dat/TuneECU/Description_Android_EN.pdf