New Gizmo

[scot in exile]

Had the POD-300 sitting in the garage for a couple of weeks finally decided to put it on yesterday, long story short the speed on the pod is not working (working but only showing 0) am I missing something I know I can always call but thought I would check you guys out first

 

[R-III-R Turbo]

I haven't speed connected up on mine either but there is an input on the PCV for speed - that has to be where the POD gets it from

 

[barbagris]

I haven't speed connected up on mine either but there is an input on the PCV for speed - that has to be where the POD gets it from

Yup. That!. Mine is connected - If you connect look at mapping by gear in the PCV.

 

[scot in exile]

thanks for the quick reply guys, now I have an auto tune connected to my pcv I also see the place for wires on the pcv but cannot for the life of me figure out how to connect that to the POD ? am I missing something simple

 

[Triple Trouble]

thanks for the quick reply guys, now I have an auto tune connected to my pcv I also see the place for wires on the pcv but cannot for the life of me figure out how to connect that to the POD ? am I missing something simple

Are you missing me Dave?

 

[scot in exile]

Each time I see you Paul it reminds me it is time for my colonoscopy **** I just saw you three months ago and I will see you in another four months.

 

[1olbull]

Are you missing me Dave?

Howdy, DUK!

 

[scot in exile]

okay checking on the Dynojet web site it looks like I need to run a 22-24g wire from the stock vehicle signal wire to the pc-v okay where the hell is the signal wire and colour- calling mybrother from Dunfermline

 

[scot in exile]

Give this a wee nudge before it disappears, I see the wee hole on the pc-v (one of seven) that the speed signal wire has to go into, I know it is a 22 or 24 g wire only part missing is where do I connect it to? and how -thinking a posilock, everything seems to be working okay--RPM, AFR,Throttle Position, injector pulse etc just want the speed to show.

 

[leatal]

Give this a wee nudge before it disappears, I see the wee hole on the pc-v (one of seven) that the speed signal wire has to go into, I know it is a 22 or 24 g wire only part missing is where do I connect it to? and how -thinking a posilock, everything seems to be working okay--RPM, AFR,Throttle Position, injector pulse etc just want the speed to show.

I believe the wire size is 20-22 g wire. I wired a 20 g to the MAP sensor and am looking to install the speed sensor wire near the triangular plug from the sensor. Anyone know where the plug is located? Got to be buried behind the engine somewhere!