vindex1963
Turbocharged
- Joined
- Aug 3, 2019
- Messages
- 888
- Location
- Payson Arizona
- Ride
- 2006 Rocket 3, 2015 Victory Cross Country
Might help a little with performance getting some cool outside air instead of across the engine hot air.
3" hole saw is a ****** to use with no two surfaces being level. I guess the chrome was hard to cut because when I was done
the Milwaukee Hole Dozer was destroyed. I also used my Dremel and a carbide end mill to rough the holes imperfections then a sanding wheel to clean them up. I used 1/8" hole size stainless perforated sheets and cut the screen just over the hole size. The Claw was scuffed with a sander and primed. I'm going to paint the Claw with black truck bed liner and over that use Plasti-Dip. The screens will be painted as close as I can to the red of the bike. Should have a really good look.
3" hole saw is a ****** to use with no two surfaces being level. I guess the chrome was hard to cut because when I was done
the Milwaukee Hole Dozer was destroyed. I also used my Dremel and a carbide end mill to rough the holes imperfections then a sanding wheel to clean them up. I used 1/8" hole size stainless perforated sheets and cut the screen just over the hole size. The Claw was scuffed with a sander and primed. I'm going to paint the Claw with black truck bed liner and over that use Plasti-Dip. The screens will be painted as close as I can to the red of the bike. Should have a really good look.