Thank you!!
Map signal is 500 . so just add 20% all over from 1000rpm - 7500rpm ?
what about the 0 column ? i figure out that each 1% is about 20 numbers . Is the 0 column is just reference? leave it 0 or change it also?
So at anything below 500 from 1200 to 7500 add 20%. (If you change fuel tables in Tune-ECU it is always percent.)
Leave the 0 column alone.
But all that is just an attempt and it does not have to work. Though it usually helps.
Also copy the 2% ETV tables in the columns down to 0% from 1500 to 7500.
So at anything below 500 from 1200 to 7500 add 20%. (If you change fuel tables in Tune-ECU it is always percent.)
Leave the 0 column alone.
But all that is just an attempt and it does not have to work. Though it usually helps.
Also copy the 2% ETV tables in the columns down to 0% from 1500 to 7500.
So at anything below 500 from 1200 to 7500 add 20%. (If you change fuel tables in Tune-ECU it is always percent.)
Leave the 0 column alone.
But all that is just an attempt and it does not have to work. Though it usually helps.
Also copy the 2% ETV tables in the columns down to 0% from 1500 to 7500.
Does your exhaust come with removable baffles to kill a few decibels? If so, try putting those in to add a smidge of backpressure and see if the popping is the same as before. I did that on my Speed Triple and the pop was less (could just be more muffled and my bad ears).
Does your exhaust come with removable baffles to kill a few decibels? If so, try putting those in to add a smidge of backpressure and see if the popping is the same as before. I did that on my Speed Triple and the pop was less (could just be more muffled and my bad ears).
On that note check your AIS (Air Injection System) is not leaking. You might consider taking the AIS off your bike. My old '05 Rocket didn't have an AIS on it, so this might be the actual source of your problem. Watch the video, he explains it pretty well.
Thanks
I will. It is just 3 plates. I don't think that the shop that installed it for me put any gasket or any kind of sealing under the plates. I will check it next week.