Corbin Gunfighter Seat

[rick danger]

Anyone use the above risers on a 2025 gt storm ?

I'd be interested in this as well. I have those risers on both my KTM's, but the Rocket looks a little more complicated with the gauge right there.

 

[Kim Turner]

I have been hesitant to get one because I didn’t like the Corbin seat on my Harley Streetglide, but I did it anyway. The seat arrived today. Looks great. Good position. But, I can’t get the latch to hook in place. I tried adjusting the forward movement but the pin is right over the latch. It will go in but probably not far enough. The instructions say that the rubber stops need to be broken in. How do you do that when the seat won’t attach? Anyone have a solution? I called Corbin but got their voicemail. Also, are you supposed to remove the metal side pieces from the stock seat and attach them to the Corbin seat? Thanks in advance.

Same problem a while back. loosen the stud that latches, put some washers on, screw back on until it latches. remove washers over time. The more riding you do, the more the seat will 'seat'.

 

[sandcritter]

Corbin is done with customers after the sale. Good product (most often) lousy company.

Been there. An expensive and protracted season-long been there.

I like the seat overall. It’s still not what I ordered, reflected plainly on the receipt, but it’s close. Believe four returns to make “right”?

Customer service management was atrocious.

 

[Kim Turner]

Been there. An expensive and protracted season-long been there.

I like the seat overall. It’s still not what I ordered, reflected plainly on the receipt, but it’s close. Believe four returns to make “right”?

Customer service management was atrocious.

Heard the 'horror stories'. Had no problems, BUT, was 'as ordered' (miracle 1)and actually fitted (miracle 2). Wider than the stock, but a bucket for my backside to fit into.

 

[Rick111]

I'd be interested in this as well. I have those risers on both my KTM's, but the Rocket looks a little more complicated with the gauge right there.

I have risers and have had the dash on them . It didn’t seeem to have enough slack in the cables so I aborted the project .