Anyone got a lathe?

BigNorm

Boobie Inspector
Joined
Apr 30, 2016
Messages
3,430
Location
Minden, NV, USA
Ride
2014 Rocket 3 Touring
I am needing four threaded bungs 1" wide drilled and tapped for M10x1.25 . I am wanting to make my own handlebar risers. These would slide into 1 1/4" round tubing. My thought is to retain the stock R3T risers and bolting them into the extentions. The only bungs I have been able to source with this thread pitch so far are 3/4"od. Any help as always is appreciated.
 

Save your time.
Jack-Be-Quick has 1.25" high spacers with new longer bolts for $40 (in USA)
Pictured on TBird here, but they fit the 1.25" round risers as on Touring models.
Website is down for the moment(???) so email me at JackBeQuick.TBird@Gmail.com
Bob
 


Bob,

What modifications, if any, has to be done to cables or routing of cables with your 1.25" risers?

bob
 
Can't seem to find a picture of RocketJohn's. Maybe he'll post one.
BTW, whether or not you buy JBQ's, you really do not want to thread into aluminum spacers. They would probably not stand up to an impact load or even hold up over time to constant vibrations. You want to go with grade 12.9 hardened bolts through the spacers into the stock risers. Good luck with your project. (...no,really!)

 
You must log in or register to reply here.

Similar threads

Bring A Trailer Rocket
Replies
0
Views
406
stingray
Triumph's Wheelie Control System Turns You Into a Hooligan With a Safety Net
Replies
5
Views
1K
Justdad
backfire on a r3 possible?
Replies
9
Views
984
Kiwicol
Added a second bike.
Replies
5
Views
902
Vector
A new direction / solution
Replies
3
Views
971
Ishrub
Menu
Log in
Register