Anyone got a lathe?

[warp9.9]

7 inches I have to ask are you trying to drive from the passenger seat? Or standing up?

 

[ruzzle]

I have a lathe but I don't use it. It just lathe there.

 

[barbagris]

7" is a serious change - Looked at different bars?

 

[barbagris]

I have a lathe but I don't use it. It just lathe there.

How long did you mill over that reply?.

 

[VABird]

I have a lathe but I don't use it. It just lathe there.

Maybe you should just chuck it!

 

[Jvheli]

I am needing four threaded bungs 1" wide drilled and tapped for M10x1.25 . I am wanting to make my own handlebar risers. These would slide into 1 1/4" round tubing. My thought is to retain the stock R3T risers and bolting them into the extentions. The only bungs I have been able to source with this thread pitch so far are 3/4"od. Any help as always is appreciated.

If you run out of options, do a quick sketch and I'll make them for you.

 

[rocketjohn]

For those interested, while it is not imperative, and maybe not at all needed on every model, on my bike, it was helpful to reroute the clutch cable from in front of the frame to drop down between the frame and engine. That gave more room on a full right turn, and for the life of me why Triumph routed it the other way I cannot fathom. The new routing is superior in every way. Touring model to be sure...Roadsters might route differently.

 

[BigNorm]

If you run out of options, do a quick sketch and I'll make them for you.

Thanks. I think I found some at bungking.com.

 

[Wannbe]

Thanks. I think I found some at bungking.com.

15 mm is only .591 in. Are there different ones on the site or did 7 in. get scrapped. I'm interested in the final result .

 

[mr hunt]

I have a lathe but I don't use it. It just lathe there.

How long did you mill over that reply?.

Maybe you should just chuck it!

These comments have been going round and round in my head but not matter how I spin them they don't seem to make sense??? After turning them over and over in my mind I've decided to file them away.