2020 Triumph Rocket 3 Fender Eliminator

[jack Arzoomanian]

Thanks for posting this. Going to get this done next week.

Me 2

 

[jack Arzoomanian]

Got her done and bent the plate

Me 2

Done! Hit a wheelie, bent the plate on the tire, go figure

 

[Lamonster]

Looks like you need some adjusting. Haven't hit mine and I did compress the suspension to make sure I had enough clearence.

 

[jack Arzoomanian]

Looks like you need some adjusting. Haven't hit mine and I did compress the suspension to make sure I had enough clearence.

Hit a hard dip and preload was only at 2 turned it up to 5. Using the taillight as the LP light plenty bright. I have a good angel on the plate and it's tucked under the taillight far enough to make it bright. The tag light that came with the bracket mounted made the plate drop about a 1" more. Watch out for full compression on the rear(heavy hit or dip) it will hit

 

[Tal]

Should keep stones and sh*t from taking the shine off the tail light lens too...
and...you can get led lights/bolts which hold the plate on too....just look like bolts with a led light in the head and of course wires.

 

[jack Arzoomanian]

Should keep stones and sh*t from taking the shine off the tail light lens too...
and...you can get led lights/bolts which hold the plate on too....just look like bolts with a led light in the head and of course wires.

Don't need them unless inspection a hole says different (whit light,red light BS)

 

[jack Arzoomanian]

Looks like you need some adjusting. Haven't hit mine and I did compress the suspension to make sure I had enough clearence.

Does that GT windscreen keep the wind off your body? I forgot how much the wind beats you up at 100mph

 

[Lamonster]

This is fully compressed. The mount is real close but the plate has plenty of room.

 

[Lamonster]

 

[Lamonster]