Removing Triumph logos from fuel tank

[TRath]

Huh, my '09 Classic had holes. Must be a touring thing.
If you're planning to put them back on, it's worth noting that (on the Classic at least) they are slightly different left to right so make sure you're putting the right one on the right side. Switch them and they just "almost" fit.

 

[Y62]

My tank is from another bike, don't know the model but most likely not a touring because the fender is for a 240 wheel. It had holes for the logos.

 

[Navigator]

Huh, my '09 Classic had holes. Must be a touring thing.
If you're planning to put them back on, it's worth noting that (on the Classic at least) they are slightly different left to right so make sure you're putting the right one on the right side. Switch them and they just "almost" fit.

I could be incorrect and did just not see them in the pic

 

[elcanaco]

I could be incorrect and did just not see them in the pic

I only get the group’s message on Saturday morning. YES there were 2 locating holes on each side of the tank and the custom paint shop is filling them and the 3 holes on the front tip of the fender before the paint work.

 

[Rick McC.]

Sounds good, looking forward to some pics when done!

 

[Y62]

I only get the group’s message on Saturday morning. YES there were 2 locating holes on each side of the tank and the custom paint shop is filling them and the 3 holes on the front tip of the fender before the paint work.

I did the same with my fender.