No doubt this has been asked before, but it might be of use to some.
I have a small issue with very small throttle openings for revs pick up.
I have all the stock air filter plumbing, stock filter, custom full '3-1 short exhaust system' and custom map 20050TORS_Dyno.
*I disabled the O2 sensor before downloading the map as it was defective, so don't know if this has something to do with it*
As I've said before it starts, idles and runs like a dream 'BUT' there is the very small issue at small openings. It's a bit hesitant on the initial pick up and occasionally jerks in 1st and 2nd when going slow.
Is there any tried and tested way of improving/eliminating this?
Cheers chaps!! Always appreciated.
I have a small issue with very small throttle openings for revs pick up.
I have all the stock air filter plumbing, stock filter, custom full '3-1 short exhaust system' and custom map 20050TORS_Dyno.
*I disabled the O2 sensor before downloading the map as it was defective, so don't know if this has something to do with it*
As I've said before it starts, idles and runs like a dream 'BUT' there is the very small issue at small openings. It's a bit hesitant on the initial pick up and occasionally jerks in 1st and 2nd when going slow.
Is there any tried and tested way of improving/eliminating this?
Cheers chaps!! Always appreciated.