R3Tex
Living Legend
I know there are several threads going around about LED headlights, but I thought I would throw another one in the mix. I installed HD Daymakers on my Roadster tonight. It was a no pain, no strain install. No trimming, no relocating brackets, I even kept the parking lamps LOL. Here's what I did...
1.) Remove the OEM headlamp by unplugging the H4 connector and cutting the yellow wire and black wire leaving the parking lamp bulb in the reflector. Put it to the side for storage, throw it in the dumpster...whatever...you won't need it anymore.
2.) Crimp, solder, then insulate using heat shrink tubing a 1/4" push on connector onto the yellow wire.
3.) Seal off the black wire with heat shrink tubing. This may not be necessary, but I'm sorta anal like that.
4.) Plug the H4 into the Daymaker.
5.) Plug the yellow wire into the red wire on the Daymaker.
You should end up with something like this...
Re-install assemble the headlight and you should end up with something that looks like this
1.) Remove the OEM headlamp by unplugging the H4 connector and cutting the yellow wire and black wire leaving the parking lamp bulb in the reflector. Put it to the side for storage, throw it in the dumpster...whatever...you won't need it anymore.
2.) Crimp, solder, then insulate using heat shrink tubing a 1/4" push on connector onto the yellow wire.
3.) Seal off the black wire with heat shrink tubing. This may not be necessary, but I'm sorta anal like that.
4.) Plug the H4 into the Daymaker.
5.) Plug the yellow wire into the red wire on the Daymaker.
You should end up with something like this...
Re-install assemble the headlight and you should end up with something that looks like this