I just installed the Eastern Beaver on my 07 Classic. Unfortunately, I did not make the modification unitil I had already melted the wire off inside the ignition barrel. I had an electrician friend solder the connection back on and it works, but I am not completely confident in the condition of the ignition. If I turn the key too far I loose power like I may have messed it up when pulling it apart. Is there a way to just take the ignition barrel completely out of the picture by installing a switch. I figure there has to be a way to just run wires to an aftermarket switch that can be located somewhere it is hard to see, rather than buying a whole new ignition barrel. Any help would be appreciated.