HELP!!! Hesitation, engine light, now no power.

TURBO200R4 said:
on my 07 the ground goes down a few inches and there is a splice and wire with a connector that has gone bad on a few rockets. behind the left panel.
Click to expand...
Is that an OBD2 port? Can any reader pull the codes?
 
Most code readers will read the obdll codes and usually will read the manufacturer's codes but will not give u a meaning for them
If u get the numbers i will get u the meanings and try to polnt you in the right direction.
The best bet is to download tuneecu and buy the lonetec cable to connect to the obdll connector.
 
Success!!!! So far.

So I took her down to my buddy's place and we tore into it. It died as I pulled into his place. No power. Turns out Turbo was **** close. We started with the ground coming off the battery. Checked both cables, wiggled them. Nothing. No power. We moved to the positive side, wiggled the positive lead and the bike powered up!!!! There is a "Y" a couple inches down the cable and a smaller wire with a connector branches off. The wire had backed itself most of the way out of the connector and it must have barely been making a connection. We disconnected it, cleaned up the ends, put it back together and taped it up. Bingo!!! The check engine light is still on, but it runs fine. It's hard to see in my pics, but it's down by the relays.

Thanks to all you guys for your advice! I hate being without my big girl....even for just a couple days.

Update....the check engine light has gone off!!!!
 

Attachments

  • IMG_20220810_195427998_HDR.jpg
    133.7 KB · Views: 38
  • IMG_20220810_195354252_HDR.jpg
    152.5 KB · Views: 41
Last edited:
You were dang close!! It was the positive side. Thank you so much for your help. Once again you saved my bacon.
 
This was definitely the problem!!! Thx, bud!
 
You must log in or register to reply here.

Similar threads

Engine light staying on
2
Replies
13
Views
394
Tripps
Tapping switches power source
Replies
2
Views
115
sandcritter
No Power To Anything
2
Replies
10
Views
832
kipper
Storm Gt hill hold not available and engine light on.
2
Replies
11
Views
559
Kiwicol
No Power
Replies
8
Views
946
RIchareno
Menu
Log in
Register