Gears not engaging, after being rough with the gear shifter.

oteczdmitriy said:
The front part does not need to be disassembled. The rear part, including the rear swingarm, wheel, fender, and air filter box (to release the wires from the bottom of the engine), must be removed
Click to expand...
Ok, so I have a Ramair air filter kit so I will need to take apart all. So I will lift the frame with a crane a the engine will be in a dolly o plataform. Sound so fun! (Crying inside)
 
Kevin frazier said:
There probably all confusing, im a red neck with little capability
Click to expand...
The one with the bulldozer....more useful than a thought! btw..how many times you change the trans? I that bad the transition on this rockets? I bought this bike used 4 months ago. 24k miles (first rocket and I am in love of this one)
 
oteczdmitriy said:
The front part does not need to be disassembled. The rear part, including the rear swingarm, wheel, fender, and air filter box (to release the wires from the bottom of the engine), must be removed
Click to expand...

BTW… I’m planning to move the bike using a motorcycle hitch hauler mount. The front wheel fits fine on the mount, but the rear tire is too wide (240mm).
My question is: what’s the best way to disconnect the driveshaft so I can haul it with just the front wheel on the mount?

this is the mount, its going be connected to my truck hitch:

 
There is no easy way to remove the driveshaft.
Planning on replacing rear tire so while doing that I will check the possibility of removing
The drive spline (without causing problems)
 
Go to a loading dock, make or buy a cradle and put it in bed of your truck, make sure to tie it down securely, or rent a trailer.
 
leocohete said:
The one with the bulldozer....more useful than a thought! btw..how many times you change the trans? I that bad the transition on this rockets? I bought this bike used 4 months ago. 24k miles (first rocket and I am in love of this one)
Click to expand...
Ive done trans a couple times, the forth will break in these and the circliips have come loose, Robinson industries or a race engineering manufacturing shop can sort it out for ya, back cut, polish, big circlips or spiralocs , billet 4th gear, tgen youre good, you can flog on it.
 
You must log in or register to reply here.

Similar threads

Gearbox rebuild question
Replies
0
Views
239
bebsy
Floppy gear selector
Replies
7
Views
444
kipper
Gearbox repair?
Replies
7
Views
619
atomsplitter
Gear position sensor 2014 roadster
2 3
Replies
23
Views
3K
TURBO200R4
Ran (nearly?) dry, now stalling in first gear
Replies
1
Views
231
atomsplitter
Menu
Log in
Register