The manual has two contradictory pieces of information in it. 1 area states using a 90/95 full synth hypoid and 170ml, and another area states 75/90 filling to the filler hole? Wtf.!?
 
The new generation synthetic gear oils are completely different to the old mineral gear oils ,Penrite gear pro 80/140 oil runs out of the container like 20/50 motor oil, we use it in our "other" bike gearbox and primary case
it quietens things down and makes the changes smooth
What do you think about the contradictory quantities though?
 
What do you think about the contradictory quantities though?

Not to worry, Fill to the point the gear lube begins to run out of the FILL hole while the bike is upright.

Mobil 1 Synthetic GL5 75/90 is ok too. I change my final drive lube every spring. It is only about 6 OZ. so why not?
 
I use the penrite mentioned already and i change it whenever i do the rear rubber or repair the gearbox....so about 17 times a year...usually comes out so clean i could put it back in the container but few hunj in oil over the life of the bike is far better thousands for new drive
 
Back
Top