snicrep
Supercharged
anybody have pics, diagrams, or good descriptions of where the crank angle sensor and auto sensor plunger are? i think i can find the vacuum lines, caps and coil leads. thanksCheck plugs yes, also check the low tension lead feeding the coils the female spade connectors loosen up and will give you a erratic miss ya can't chase down. Its a 08 so start thinking about installing new vacuum lines and the nipple plug caps. You do not need to pull the drive shaft just the bevel box on the rear one shock bolt 4 bevel box bolts. You'll see the drive shaft splines grease the. And the internal cup on the box. I leave a blob in the bottom of the cup. This is a good time to renew the bevel box oil. Watch out not to over torque the drain plug its hollow and filled with a magnet so it strips the threads off easily. The fill plug is higher torque and much beefier. While your down there clean the positive to the starter and pull the crank angle sensor and wipe it off clean. Its a magnetic pick up so it can collect some trash. There will only be a table spoon of oil coming out when you do this. 30,000 miles you should check the drop measurement on the auto tensioner plunger (never turn motor over when the centre bolt is out of the tensioner.) If the plunger drop is 16 mm its time to add the spacer to bring the spring tension back up to specifications.