Anyone got a lathe?

warp9.9 · Feb 25, 2017

7 inches I have to ask are you trying to drive from the passenger seat? Or standing up?

ruzzle · Feb 25, 2017

I have a lathe but I don't use it. It just lathe there.

barbagris · Feb 26, 2017

7" is a serious change - Looked at different bars?

barbagris · Feb 26, 2017

ruzzle said:
I have a lathe but I don't use it. It just lathe there.

How long did you mill over that reply?.

VABird · Feb 26, 2017

ruzzle said:
I have a lathe but I don't use it. It just lathe there.

Maybe you should just chuck it!

Jvheli · Feb 26, 2017

BigNorm said:
I am needing four threaded bungs 1" wide drilled and tapped for M10x1.25 . I am wanting to make my own handlebar risers. These would slide into 1 1/4" round tubing. My thought is to retain the stock R3T risers and bolting them into the extentions. The only bungs I have been able to source with this thread pitch so far are 3/4"od. Any help as always is appreciated.

If you run out of options, do a quick sketch and I'll make them for you.

rocketjohn · Feb 26, 2017

For those interested, while it is not imperative, and maybe not at all needed on every model, on my bike, it was helpful to reroute the clutch cable from in front of the frame to drop down between the frame and engine. That gave more room on a full right turn, and for the life of me why Triumph routed it the other way I cannot fathom. The new routing is superior in every way. Touring model to be sure...Roadsters might route differently.

BigNorm · Feb 27, 2017

Jvheli said:
If you run out of options, do a quick sketch and I'll make them for you.

Thanks. I think I found some at bungking.com.

Wannbe · Feb 27, 2017

BigNorm said:
Thanks. I think I found some at bungking.com.

15 mm is only .591 in. Are there different ones on the site or did 7 in. get scrapped. I'm interested in the final result .

mr hunt · Feb 27, 2017

ruzzle said:
I have a lathe but I don't use it. It just lathe there.

barbagris said:
How long did you mill over that reply?.

VABird said:
Maybe you should just chuck it!

These comments have been going round and round in my head but not matter how I spin them they don't seem to make sense??? After turning them over and over in my mind I've decided to file them away.

Anyone got a lathe?

warp9.9

Pocałuj mnie w dupę

ruzzle

Moderator

barbagris

Mad Scientist

barbagris

Mad Scientist

VABird

.060 Over

Jvheli

Nitrous

rocketjohn

Top Fuel

BigNorm

Boobie Inspector

Wannbe

Supercharged

mr hunt

Living Legend

Similar threads

Anyone got a lathe?

Pocałuj mnie w dupę

Moderator

Mad Scientist

Mad Scientist

.060 Over

Nitrous

Top Fuel

Boobie Inspector

Supercharged

Living Legend

Similar threads

Privacy & Transparency

Privacy & Transparency