tripX
.040 Over
Fitted Ramair and cat delete single open muffler. The is a sensor in the Ramair intake I noticed there is one in the old airbox as well . what if anything should be done with this sensor. Cheers
Jvheli
Nitrous
Using the extension plug for the AIT just move it from the removed plenum to the Ramair filter. Clamp using the supplied clamp.
It’s all covered in the instructions!
It’s all covered in the instructions!
tripX
.040 Over
Yes I have done that . I'm talking about the sensor in the airbox under the seat .
tripX
.040 Over
Thanks I just found out it's a map sensor so it will stay in place
Kevin frazier
Widowmaker!
Cool avatar that slammed truck and rocket go good together, bad boy style
warp9.9
Pocałuj mnie w dupę
The map sensor was attached to the plenum via 1 bolt it was mounted a few inches behind the AIT on the plenum. It also has a lage vacuum line. The sensor under the seat in the air box where the filter goes senses atmospheric pressure changes ie. altitude, it is the barometric pressure sensor. It can stay there . A few might have moved it so it wasn't sitting in a stagnant box of hot air. A better choice is to plumb fesh air into the box cooling the box that your sitting on.
Last edited:
TheKid
Top Fuel
- Joined
- Feb 2, 2011
- Messages
- 1,919
- Location
- Dry Ridge Ky, USA
- Ride
- 2007 Rocket III Standard /2010 R3T
A supercharger gives attitude. A joint gives me altitude
Jvheli
Nitrous
That stays put. MAP sensor gets a small adell clamp and attaches to the fuel rail if memory serves.
tripX
.040 Over
Thanks I was driving in country south Australia and the car was parked so I pulled up and took a pic
