Kicking ideas around.

[BigNorm]

139 cubic inch S&S motor. 113/126/132 and 139 Cubic Inch Orca Motors

They also have a turbo kit to put on it.

 

[sonny]

Will not fit into Softail frame. Plus the engines have a bad habit of blowing up after about 20,000 miles. Key word here is race engine.

 

[Willyone]

Here's a few design ideas for ya

 

[sonny]

Would not look right with fatboy solid rims

 

[leatal]

Here's a few design ideas for ya

Did this guy in the beginning of the clip just run 7.9 sec/145 speed in the quarter mile? I know the Carpenter folks ran an 8.9, but have not seen anyone in a Rocket run quicker. You would think if a an antiquated Harley motor can run this fast, surely a Rocket motor built for dragging could do much better! Anyone seen a quicker time than the Carpenter run?

 

[TriumPhil]

Pretty sure that was a tenth of a mile run in that clip, leatal!

Pretty good for a stock Motor Company engine.

 

[TriumPhil]

sonny, there might be a couple good ideas in this vid...

 

[sonny]

None of them would look right with Ape Hangers

 

[Dr.D]

I traded away a 110hp/120tq Harley CVO Fatbob for a R3.

 

[Ishrub]

I traded away a 110hp/120tq Harley CVO Fatbob for a R3.

A wise decision it was too!