Tail End Paddy
Standard Bore
Just been investigating a leak on the induction, though one of the small tubes has come off. Been like that it for a while, can hear a "sucking" if you stand on the left of the bike without a helmet.
Turns out, whoever had this off last, didn't put the pipe clip back on properly. Which has chewed up, the rubber tube between the throttle-bodies and the head, were the tube us clamped to the throttle body. Front One.
Short of taking the whole of the inlet side of, and replacing it, any ideas about patching it up, at least temporarily?
Would a rubber patch and some silicone sealer hold? I guess it's worth a try?
Turns out, whoever had this off last, didn't put the pipe clip back on properly. Which has chewed up, the rubber tube between the throttle-bodies and the head, were the tube us clamped to the throttle body. Front One.
Short of taking the whole of the inlet side of, and replacing it, any ideas about patching it up, at least temporarily?
Would a rubber patch and some silicone sealer hold? I guess it's worth a try?