hp/torque mods and dyno sheets

cusso ken said:
In Oz it was ABOUT FACE ,turning 180 degrees clockwise with the left knee bending
Click to expand...

I wanna see that done, M8!
On count one, the right foot was dropped to the rear and we rotated clockwise. On count two, the left foot was slammed forward against the right heel.
 
1olbull said:
I wanna see that done, M8!
On count one, the right foot was dropped to the rear and we rotated clockwise. On count two, the left foot was slammed forward against the right heel.
Click to expand...

G,day Bull ,always to the right and pivoting on the right heel and bringing the left boot round smartly,
 
cusso ken said:
G,day Bull ,always to the right and pivoting on the right heel and bringing the left boot round smartly,
Click to expand...

Youse blokes do everything back asswards?
Pivot is on the right toes and left heel until the heels come together facing 180° from start.
 
Last edited:
1olbull said:
Youse blokes do everything back asswards?
Pivot is on the right toes and left heel until the heels come together facing 180° from start.
Click to expand...

It is probably because we are hanging up side down on the planet,
if you U Tube marching Out Parades at Kapooka the Australian Army Recruit Training Battalion, you will see how the Aussies do it, the early clips show the drill with the" Elephant Gun " the 5.5kg 7.62mm SLR
 
1olbull said:
Click to expand...
Carpenters single 1500CC engine stock chassis test bike makes 500+HP so that's the most Ive heard of so far That's until we install the 2300CC engine and then it should be good for 700+ HP NOW that's some serious HP
 
IMFASTTOO said:
Carpenters single 1500CC engine stock chassis test bike makes 500+HP so that's the most Ive heard of so far That's until we install the 2300CC engine and then it should be good for 700+ HP NOW that's some serious HP
Click to expand...

So tell us more about these engines - why destroke to 1500? To allow a higher rev limit than 9000?
 
R-III-R Turbo said:
So tell us more about these engines - why destroke to 1500? To allow a higher rev limit than 9000?
Click to expand...
WE did that so we could run 2 engines in the Castrol Triumph Streamliner the limit is 3000CC and we did raise the rev limit to 10000 rpm
 
You must log in or register to reply here.

Similar threads

Would like to ride the ultimate torque machine, is this a good deal?
2 3
Replies
22
Views
2K
Ronmold
Which sensors disable ignition and injection?
2 3
Replies
22
Views
1K
TURBO200R4
Tall guy mods?
Replies
5
Views
820
Mike188
What’s everyone running for clutch and where did you get them?
Replies
8
Views
479
Gerald
Looking for oem tank and knee pads
Replies
0
Views
265
Earthquake
Menu
Log in
Register