So, I've been taking a break from pulling my hair out. Still completely baffled at what's going on. At last attempt, pulled injectors out, still connected, all 3 squirted the same. Pulled one plug out each cylinder, compression test, 170/175/170 and found NOW, #3 had no spark !!!??? So changed that coil, and had spark all 3. TuneEcu reset adapt, adjusted ISCV .60/.74 fired her up, and was running on all 3, but dropping a cylinder, or 2 at below 1500 rpm, backfiring etc. and idle way too low. Got throttle body's close 640 range. Pulled stepper motor, and doesn't seem to be extending as far as another one I have, so will swap it out, on my next adventure into the unknown. It is much closer, but still far from right, and I'm totally blown away, at all the different things that have been going on. Remember, this all started with #1 being dead, then #2, then #3, I just dunno. Will also look at the crank position sensor AGAIN.