Sepu4
Standard Bore
- Joined
- Nov 21, 2020
- Messages
- 10
- Ride
- Rocket III
Hi, I have splitted the cases for the bolt selector job and I've seen that the bearing on the gears shaft is wrong positioned (I think).
On the lower crankcase is an oil drain/ chanel for oil to flows in the bearing but on that side bearing is sealed. Is that OK? Please check the photos.
I have ordered new bearings for the output/ torsional shaft.
Thanks for your help.
On the lower crankcase is an oil drain/ chanel for oil to flows in the bearing but on that side bearing is sealed. Is that OK? Please check the photos.
I have ordered new bearings for the output/ torsional shaft.
Thanks for your help.