Daddy Rabit
.020 Over
- Joined
- Mar 21, 2009
- Messages
- 22
I tried to install a 1" barsnake in my handlebars to no avail. Has anyone done so?
Barsnake Installation on standard Rocket
- Thread starter Daddy Rabit
- Start date
Sidecar Flip
Living Legend
You can't because of the design of the handlebar. The bar ends mount to a cross welded plate on the ends. You only option is change bars or fill the bars with small shot like No.8 birdshot which will be appreciably cheaper than the barsnake and available at any gun shop.
cane corso
Turbocharged
bar snake
I was thinking of doing it and my dealer said that the bar snake comes in a liquid and that could be used I think it was about $65.00 but my dealer wanted $100.00 to do it but you need to take your handle bars off and tip them on its side and take the throttle side off and poor it in they and let sit for four hours.
One day when my bike needs to go in for something I'll then have them do it.
I was thinking of doing it and my dealer said that the bar snake comes in a liquid and that could be used I think it was about $65.00 but my dealer wanted $100.00 to do it but you need to take your handle bars off and tip them on its side and take the throttle side off and poor it in they and let sit for four hours.
One day when my bike needs to go in for something I'll then have them do it.
Daddy Rabit
.020 Over
- Joined
- Mar 21, 2009
- Messages
- 22
Barsnake
I tried to no avail. Rip the end cap off and there was no way to pull the barsnake through. Heating it up lubing it up , nothing worked.
I tried to no avail. Rip the end cap off and there was no way to pull the barsnake through. Heating it up lubing it up , nothing worked.
Sidecar Flip
Living Legend
I never considered the Rocket a handlebar shaker except above 100 mph. Obviously you've never ridden a vertical twin or a big single.
Similar threads
